TempAlert Support

Search articles and videos to get the most out of your TempAlert Device

Reset Search
Search
 

Article

How To Connect The ZPoint Sensor To The CELL

« Go Back

Information

 
Details
The Z-Point Wireless Sensor, also known as a Node, relies on a properly-functioning Cellular Edition (aka, Gateway) to ensure successful data transmission. The Node does not require access to a cellular network, only to the Gateway.

Steps to connect a Node to a Gateway:
  1. Ensure that your Gateway is turned on, and has a working cellular connection. Note: If the Status light is blinking single or double green, your connection is functioning properly
  2. To turn on the Node, use a pen tip or a pin to push in the On/Off button, which is located by the power cord on the device.
  3. Ensure that the Node is within range of a working Gateway. The typical range is 1000 feet with direct line of sight, and 300 feet with obstructions.
  4. Within one minute of pressing the On/Off button, the Node automatically connects to the closest working Gateway.
  5. The status light flashes a single green blink when a successful connection has been established.
Notes:
  • Different light schemes may indicate connection issues. The following table identifies the possible scenarios
  • If you continue experiencing LED issues, please review our Node Troubleshooting Guide
User-added image

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255

 

Browse By Product
Still Need help?
Submit a Ticket